The fake Da Vinci IW376026 V4 is the fourth-generation replica of the IWC Da Vinci automatic, and it is the version most replica buyers now treat as the closest match to the genuine reference. It pairs a re-cut case profile with a cleaner dial print and a higher-grade automatic movement, so V4 listings cost more than leftover V1 to V3 stock. If you are shopping this reference, the V4 is the baseline to compare everything else against.
What is the fake Da Vinci IW376026 V4?
V4 is a factory version number, not an official IWC code. Replica makers release a reference in waves, fix the loudest flaws, then re-label the result V2, V3 and V4.
On this Da Vinci, the V4 build focuses on the parts people see first: the case silhouette, the crown, the dial text weight and the date window position. Older versions carried a thicker mid-case and a flatter crystal, which read as off next to the genuine watch.
How do you spot a V4 build?
Case and crown
The lugs on a V4 taper with the same curve as the genuine case, and the crown sits flush against the case band. Look for crisp logo relief on the crown rather than a blurred stamp. A V2 or V3 case usually shows softer lug edges and a small gap where the crown meets the tube.
Fake Da Vinci IW376026 V7: What You Need to Know
Dial, hands and date
Dial print on the V4 is thin and sharp, and the applied markers catch light on their polished bevels. The date sits centered in its aperture; if it rides high or sits left, the dial is an earlier revision.
Movement and caseback
Most V4 units run a Miyota 9015 or a decorated Asian automatic, and both hack and wind with little resistance. Caseback engraving is laser etched instead of stamped, and the reference number spacing follows the genuine layout.
What should you check in QC photos?
- Marker alignment at 12 and 6, shot straight on.
- Date centering across three different dates.
- Brushing direction on the bezel and case, which must match on both sides.
- Lug spring bar holes, checking they are drilled evenly.
- Timegrapher reading, aiming for under ten seconds a day variance.
What does a V4 Da Vinci IW376026 cost?
Entry V4 units with a basic automatic and a leather strap run about 250 to 320 US dollars. Higher tiers with a Miyota 9015, sapphire with inner anti-reflective coating and a steel bracelet sit near 380 to 480 US dollars.
Anything far below that range is usually old V2 or V3 stock sold under a new label. Ask for the factory name and a dated photo before you pay.
Will it pass as the real thing?
At arm's length and in normal light, a well-built V4 reads correctly on the wrist. Up close, the crystal reflections, the rotor finishing and the strap leather are where it separates from a genuine Da Vinci.
Treat it as a look-alike, not a watch you can hand to a boutique for service.
FAQ
Is the V4 the best replica of this reference?
At this price point, yes. It fixes the case and dial issues that defined V2 and V3, and no current version beats it on those two points.
Does it take genuine IWC straps?
Most V4 cases use standard lug widths, so genuine and aftermarket straps in the right size usually fit. Confirm the lug width in the listing before ordering a strap.
Can I swim with it?
Do not. Replica gaskets are rarely pressure tested, so keep it away from showers, pools and salt water.
How long will it last?
With a Miyota 9015 inside, expect several years of daily wear before a service is needed. Cheaper movements tend to lose accuracy sooner.